Prior to 1905 the best and most accepted age of the Earth was that proposed by Lord Kelvin based on the amount of time necessary for the Earth to cool to its present temperature from a completely liquid state.Although we now recognize lots of problems with that calculation, the age of 25 my was accepted by most physicists, but considered too short by most geologists. Recognition that radioactive decay of atoms occurs in the Earth was important in two respects: Principles of Radiometric Dating Radioactive decay is described in terms of the probability that a constituent particle of the nucleus of an atom will escape through the potential (Energy) barrier which bonds them to the nucleus.The energies involved are so large, and the nucleus is so small that physical conditions in the Earth (i.e. The rate of decay or rate of change of the number N of particles is proportional to the number present at any time, i.e.
Thus, if we start out with 1 gram of the parent isotope, after the passage of 1 half-life there will be 0.5 gram of the parent isotope left.
After the passage of two half-lives only 0.25 gram will remain, and after 3 half lives only 0.125 will remain etc.
To see how we actually use this information to date rocks, consider the following: Usually, we know the amount, N, of an isotope present today, and the amount of a daughter element produced by decay, D*.
By definition, D* = N-1) (2) Now we can calculate the age if we know the number of daughter atoms produced by decay, D* and the number of parent atoms now present, N.
The only problem is that we only know the number of daughter atoms now present, and some of those may have been present prior to the start of our clock. The reason for this is that Rb has become distributed unequally through the Earth over time.
We can see how do deal with this if we take a particular case. For example the amount of Rb in mantle rocks is generally low, i.e. The mantle thus has a low If these two independent dates are the same, we say they are concordant.We can also construct a Concordia diagram, which shows the values of Pb isotopes that would give concordant dates.The Concordia curve can be calculated by defining the following: ).Zircon has a high hardness (7.5) which makes it resistant to mechanical weathering, and it is also very resistant to chemical weathering. Chemically, zircon usually contains high amounts of U and low amounts of Pb, so that large amounts of radiogenic Pb are produced.Other minerals that also show these properties, but are less commonly used in radiometric dating are Apatite and sphene.If a zircon crystal originally crystallizes from a magma and remains a closed system (no loss or gain of U or Pb) from the time of crystallization to the present, then the Discordant dates will not fall on the Concordia curve.